PREPARATION
|
| • |
All surfaces should be cleaned before sealing for best penetration and performance of a coating. Remove algae, grime or mildew with appropriate cleaners.
|
APPLICATION
|
| • |
Do not use if air or surface temperature is below 35°F.
|
| • |
Do not apply in rain or when rain is imminent.
|
| • |
DO NOT THIN. Mix well. Stir contents or shake thoroughly prior to use.
|
| • |
Apply two even coats wet on damp with garden sprayer, brush, air-assisted and/or airless sprayer. Use medium spray pattern. |
| • |
When recoating, apply as soon as previous coat has penetrated the surface.
|
| • |
For best results, apply in the evening, out of direct sunlight, and at cooler temperatures.
|
| • |
Apply to all surfaces and ends.
|
| • |
Do not use with other waterproofing products.
|
| • |
It is recommended that Seal-Once™ be applied to docks while on land or that you place a tarp under existing docks to catch drips or overspray.
|
| • |
Approximate coverage: 300 square feet per gallon per coat.
|
DRYING TIME
|
| • |
Allow water to evaporate before subjecting surface to light foot traffic; 24-48 hours for full cure, depending on temperature and humidity.
|
CLEAN UP
|
| • |
Clean equipment and brushes with warm, soapy water.
|
| • |
Store unused product above 32°F, protect from freezing.
|
|
|
|
|
|
|
|
|
|
|
|
Return to Top
|
